Tutorial: a bracelet with golden nuts

We are searching data for your request:

Forums and discussions:

Manuals and reference books:

Data from registers:

Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Go to search results >>>

After struggling with the assembly instructions, your new furniture is finally assembled. Finally, it is that you think until placing your eyes on these three screws and two remaining bolts at the bottom of the bag. Were these screws too much? No, certainly not. Will the furniture still hold? Hard to say. Far from letting you embark on this infernal spiral, you reacted with great wisdom by starting by keeping these bolts as close as possible to you. Well done, that's exactly what you had to do. And today, since your furniture is still standing, you will be able to learn how to make a bracelet with nuts (the famous ones)!

Equipment

- a lobster clasp - twenty golden nuts 10 mm in diameter - six golden nuts 7 mm in diameter - a suede lace 200 cm long Budget: about 15 € Duration: 1 hour

Steps

1. To begin, pass the lace through the lobster clasp. Tie a knot, then start braiding the lace for five centimeters.
2. Continue braiding the lace, but incorporating a nut at each pass. Start with twenty 10mm nuts, then finish with the six 7mm nuts.
3. Continue the braid for about thirty cm.
4. Tie a knot and secure the lobster clasp.

Finally

Wrap the bracelet around your wrist, voila! Depending on the desired result, you can make a longer braid to make more turns around your wrist!

Did you like this tutorial? Send us photos of your version of this DIY on our Facebook page, and find other ideas on our Pinterest!